文章摘要
杜媛英,李明.几种不同衬层材料水润滑轴承的润滑特性分析[J].润滑与密封,2018,43(12):52-56
几种不同衬层材料水润滑轴承的润滑特性分析
Lubrication Characteristics Analysis of Several Water Lubricated Bearings with Different Lining Materials
  
DOI:103969/jissn0254-0150201812010
中文关键词: 衬层材料  水润滑轴承  衬层变形  水膜压力  摩擦因数
英文关键词: lining materials  water lubricated bearing  lining deformation  water film pressure  friction coefficient
基金项目:国家自然科学基金项目(11372245);陕西省自然科学基金重点项目(2018JZ1001);西安科技大学培育基金项目(201632).
作者单位E-mail
杜媛英 西安科技大学工程训练中心 duyuanying123@126.com. 
李明   
摘要点击次数: 96
全文下载次数: 0
中文摘要:
      以船舶水润滑轴承为研究对象,建立水润滑轴承双向流固耦合模型,采用有限元法研究偏心率为06时,赛龙、飞龙、丁腈橡胶和超高分子聚乙烯4种不同衬层材料水润滑轴承的润滑特性。研究结果表明:转速一定时,4种衬层材料沿轴向和周向的衬层变形分布较为一致,其中丁腈橡胶衬层的变形最大;4种衬层材料沿轴向和周向的压力分布趋势也较为一致,最大的压力值均出现在210°~270°之间,同时在270°~30°之间水膜压力波动较大。4种衬层材料的摩擦因数均随转速的增大呈现先增大后减小的趋势,其中丁腈橡胶的摩擦因数最大,超高分子聚乙烯的摩擦因数最小。
英文摘要:
      The bidirectional fluid structure coupling model of water lubricated bearing for marine was established by using the finite element method.The lubrication characteristics of water lubricated bearings with four different lining materials of Tenmat,Thordon,nitrile rubber and ultra high molecular polyethylene were studied by numerical method when the eccentricity was 06.The results show that,when the speed is constant,the deformation distribution of four lining materials is consistent in the axial and circumferential directions,and the deformation of nitrile rubber lining is the largest.The pressure distribution trends of the four materials in the axial and circumferential directions are also consistent under constant speed condition,and the maximum pressure values appear at the angle between 210° and 270°,while the water film pressure fluctuation is larger between 270° and 30°.With the increasing of rotational speed,the friction coefficient of four lining materials is first increased and then decreased.The friction coefficient of nitrile rubber is the largest,and the friction coefficient of ultra high molecular polyethylene is the smallest.
查看全文   查看/发表评论  下载PDF阅读器
关闭

分享按钮